Product specifications

PERIPHERALS
Sharp Electronics Corporation
Section-3: Printers
A variety of printers may be configured with the UP800 system. As a basic rule, the
following steps may be used for each peripheral device:
1. BUILT-IN/RECEIPT Printer setup
Procedure
Enter the SRV-Mode as outlined in Section -1
① Select [2 SETTING]
② Select [01 DEVICE CONFIG]
③ Select [01 BUILT-IN PRINTER]
④ Choose the desired parameters:
° Light & Shade
° Image Footer Å to view the choices printers depress the [DECIMAL or SBTL] key
⑤ Depress the [CASH] key when all settings are completed
The menu will return to the Device Config Sub-Menu
⑥ Select [04 RECEIPT PRINTER]
⑦ Choose the desired parameters:
° Auto Cutter Å to view the choices printers depress the [DECIMAL or SBTL] key
° Tray ST Feed#
° Depress the [CASH] key when all settings are completed
The menu will return to the Device Config Sub-Menu
⑧ Depress the [CANCEL] key to return to the SRV Mode Setting Sub-Menu
NOTE: When “ALL” devices are assigned to the desired Channel No., it is recommended
that a PROGRAM Reset be performed.
Assignment Method: The CHANNEL NO. Assignment is required at the machine
where the printer is physically connected. For the Inline configuration – the
TERMINAL and CHANNEL of the machine where the printer is physically located is
required.
Please consider the general rules listed below when using this feature:
• A printing device can not be assigned to a Channel where a non-printing device is
already assigned (ex: SCALE).
Page 78 of 246