Product specifications

FILE ALLOCATION
Sharp Electronics Corporation
Department Mark Down (File Group #4)
It is possible to report item coupons and discounts by each department when the File Group
No. 4: DEPT MARK DOWN file has been allocated. To create this file in memory you must
create the file as follows:
Procedure:
Enter the SRV-Mode as outlined in Section -1
① Select [2 SETTING]
② Select [08 FILE]
③ Select [01 DEPARTMENT]
④ Select [04 DEPT MARK DOWN]
⑤ Toggle the record selection to “CREATE” (depress the [.] key) followed by depressing
the [ENTER] key.
Allocation Method: File Group #5: DEPT MARK DOWN is allocated the same at the
Standalone, Master and Satellite and follows the File Group #1: DEPT settings
PLU/UPC Items (File Groups #6, #7, #8, #9 #10, #11, #12, #13, #14, #15, #16, #17)
In the UP800, the PLU and UPC file group is shared. The system identifies a PLU as an
article item with 5 or less digits and an UPC as an article item with 6 – 13 digits. In File
Allocation, PLU refers to both PLUs and UPCs.
File Group #6 is the “parent” File Group in which the total number of PLU/UPC items is set.
Procedure:
Enter the SRV-Mode as outlined in Section -1
① Select [2 SETTING]
② Select [08 FILE]
③ Select [02 ITEMS]
④ Select [06 PLU/UPC]
⑤ Enter the desired number of PLU records (00000 – 99999)
⑥ Depress the [ENTER] key
NOTE: The PLU/UPC file is a dynamic type allocation. In summary this means that when
you allocate a specific number of PLU/UPC items; only the number of PLU items assigned
to a department is held in memory. The total number of PLU/UPC records is dependent on
the available memory.
Allocation Method: File Group #6: PLU/UPC is allocated to the same size at the
Standalone, Master and Satellite.
Page 51 of 246