Product specifications

SD Card Utilities
Sharp Electronics Corporation
The folder structure on the SD memory card is as follows:
3. Loading or Saving Data
The UP-800 supports the loading of programming data and ALLRAM data and supports the
saving of sales data, electronic journal data, or programming data to the SD memory card.
NOTE: You must set the correct folder name before any saving or loading operation.
Failure to do so will result in unintentionally overwriting a program.
Load Procedure:
• Perform a PROGRAM RESET to enter SRV mode. (Toggle the RESET switch
located on the right hand side of the unit.)
• Press [6 SD CARD MODE]
• Select [2 LOADING]
• Select one of the following: [1 PROGRAMMING DATA] or [2 ALL RAM DATA]
• At the “Are You Sure Prompt” prompt, choose [1.YES]
Save Procedure:
• Perform a PROGRAM RESET to enter SRV mode. (Toggle the RESET switch
located on the right hand side of the unit.)
• Press [6 SD CARD MODE]
• Select [1 SAVING]
• Select one of the following: [1 SAVE ONLY] or [1 SAVE & CLEAR]
• At the “SD CARD JOB – SAVING prompt, select [1.OK]
Page 244 of 246