Product specifications

EFT&GIFT CARD
Sharp Electronics Corporation
5. PGM2 mode programming:
The PGM2 mode-programming settings outlined in this section are recommended settings
for a typical implementation of the UP-800 EFT function for credit card, debit card and/or
personal checks.
EFT Settings:
Procedure:
Enter the PGM2-Mode by depressing the [MODE] key and selection [6 PGM2 MODE]
① Select [15 EFT SETTING]
② Select [1 EFT PRESET]
③ Select [4 PRESET]
④ Set the following parameters time-out values as shown below followed by depressing the [ENTER]
key
o TIMEOUT1 = 010
o TIMEOUT2 = 180
o TIMEOUT3 = 3000
⑤ Set the TEL NO. as instructed for DIAL OUT purposes – using the [TEXT] keyboard
o Example: TEL NO. = 1,2159973963
⑥ Set the TEL ID to the designated number provided by Datacap for that merchant file or DIAL OUT
purposes
⑦ Set TEL MODE to the desired setting followed by depressing the [ENTER] key
⑧ Set FTS MODE = ENABLE for Inline systems or DISABLE for Stand-alone machines
⑨ Set the AMOUNT% only when CH. Tips are used
⑩ Depress the [ENTER] key to finalize the settings
⑪ Depress [CANCEL] when at the EFT SETTING sub-menu to exit to the PGM2 Main-
Menu
NOTE:
The AMOUNT% is used as a calculation basis for DataTran’s Authorization Amount
parameter. It is recommended to set this parameter = 15.00% - 50.00% when using the CH
Tip function
Assignment Method:
When using Nova or any other Host-based service, the Amount% should be preset to
%0. 00
Page 206 of 246