Product specifications

INLINE SYSTEM
Sharp Electronics Corporation
Section-2: Inline System Connection
Prior to programming, it is important to insure that the hardware connections necessary for
each terminal are accomplished. As a basic rule, the following steps may be used for each
peripheral device:
1. Connecting the UP-800:
Procedure:
① Connect the specified LAN cable to the Ethernet port marked “LAN”
② Install a ferrite core (part no. RCORF6699BHZZ) within 3 cm of the connector on the
connection cable to reduce interference
2. Cabling Specifications:
The below guideline for cabling should be observed when connecting a UP-800 as an Inline
terminal:
Cabling Specifications:
Specifications & Requirements
Maximum Cable Distance 328 Feet per run (from POS to Hub)
Hub 10Base-T Requirements
Straight RJ45 CAT 5 Cable UTP 24 AWG with
shielded connector.
The Electrical Industries Association (EIA)
divides UTP into different categories by quality
grade (average wiring grade -AWG).
The rating for each category refers to
conductor size, electrical characteristics, and
twists per foot. UTP cables consist of four
pairs of unshielded copper wires twisted
around each other and bundled with resin and
coated as a single line. Cable connectors
should be 8-core (RJ-45) shielded modular
jacks.
Page 122 of 246