Instruction manual

Operation
Firmware Overview
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 3-5
submenu contains related instrument settings. This chapter describes each
submenu and screen in detail. Refer to the appropriate sections for more
information.
Power-up
Screen
Self Test
Screen
Run Screens
Main Menu
Range
Integration Time 24Hr Averages Calibration Factors Instrument Controls Diagnostics Alarms Service Password
Conc Units Avg SHARP SHARP Bkg Measurement Mode Program Versions Alarms Detected RH/TEMP Calibration Set Password SHARP Range Avg Time SHARP Coef Set Flow/Pump Voltages Instrument Alarms
Ambient RH
Lock Instrument
Set Custom Ranges Neph Bkg Set Heate
r
Motherboard Filter Tape Counte
r
Ambient Temp
Change Password
Neph Mode Control Interface Board Filter Tape Change Sample Temp
Remove Password
Stdby Off I/O Board Bench Flow Temp
Unlock Password
Sample RH Detector Board Motherboard Status
Pres/Vacuum Calibration
Cal Temp Nephelometer Board Interface Status Baro Press Span RH Threshold
RH/Temperatures
I/O EXP Status Vac/Flo
w
Values Temp Threshold Ambient RH
Detector Alarms Flow Calibration
Restore Prev Values
Filter Tape Control
Sample RH Board Status Auto
Manual Ambient Temp Alpha Manual
Bench Sample Temp Beta
Mass Calibration
Tape Flow Temp
Neph Alarms
Thermal Coefficient
Mass Limit Board Temp Board Status Vacuum Coefficient Next Time
Pressure/Vacuum
Neph Sample Baro Coefficient
Start Date/Time Barometric Neph Cal Mass Coefficient
Period Vacuum Neph Temp Alpha Eff Coefficient Counter Flow Neph RH
Detector Calibration
Tape/Zero Ratio
Flows
LED Current Auto
Volumetric Conditions Detector Status
Ref Det Volt Manual
Temperature Mass
RH/Temperature Alarms Neph Calibration
Pressure Alpha Ambient RH Neph RH
Datalogging Settings
Beta Sample RH Neph Temp
Select SREC/LREC Beta Corr Ambient Temp Neph SRC Level View Logged Data Beta Ref Sample Temp
Analog Out Calibration
Erase Log
Nephelometer Status
Flow temp Voltage Channel 1-6
Select Content NEPH Temp Board Temp Current Channel 1-6 Commit Content NEPH RH
Pressure/Vacuum Alarm
s
Analog Input Calibration
Reset to Default Content LED Current Baro Pres Input Channel 1-8 Configure Datalogging Ref Detector Vacuum
Display Pixel test
Communication Settings CRn
Flow
Restore User Defaults
Serial Settings
Analog Input Readings Flow Alarms Restore Factory Defaults
Instrument ID IN 1-8
Conc Alarms
Communication Protocol
Analog Input Voltages
Streaming Data Config Analog In 1-8 TCP/IP Settings
Digital Inputs
I/O Config
Input 1-16
Output Relay Settings
Relay States
1-10 Output 1-10
Digital Input Settings
Test Analog Outputs
1-16 ALL
Analog Output Config Voltage Channel 1-6
All Voltage Channels
Instrument Configuration
All Current Channels I/O Expansion Board Voltage Channel 1-6 Detector A Current Channel 1-6 Detector B
Screen Contrast Contact Info Service Mode (on/off) Date/Time Timezone
Figure 3–3. Flowchart of Menu-Driven Firmware