Instruction manual

Installation
Connecting External Devices
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 2-19
The analog outputs are arranged on the rear panel connector as shown in
Figure 2–9. See Table 2–3 for channels and pin connections.
Figure 2–9. Pin-Out of Rear Panel Connector
Table 2–3. Default Analog Outputs
Channel Connector Pin I/O Terminal Pin Description
1 14 1 PM
2 33 3 AVG PM
3 15 5 NEPH
4 34 7 AVG NEPH
5 17 9 SHARP
6 36 11 AVG SHARP
Ground 16, 18, 19, 35, 37 2, 4, 6, 8, 10, 12 Signal Ground
Note All channels are user definable. If any customization has been made
to the analog output configuration, the default selections may not apply. ▲
Figure 2–10 shows the recommended method for attaching the cable
(customer supplied) to the terminal board using the included tie-down and
spacer. Table 2–4 identifies the connector pins and associated signals.
D/O Terminal Board