Instruction manual

Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 2-1
Chapter 2
Installation
The following installation procedures for the Model 5030i describes
packaging, lifting the instrument, unpacking the instrument, setup and
installation, including the sample tube and pump, and attaching the analog
and/or digital outputs to a recording device. The installation should always
be followed by instrument calibration as described in the “Calibration”
chapter of this manual.
This chapter provides the following recommendations and procedures for
installing the instrument:
● “Packaging and Transport” on page 2-1
● “Lifting” on page 2-2
● “Unpacking and Inspection” on page 2-2
● “Acceptance Testing and Startup Procedures” on page 2-3
● “Setup” on page 2-10
● “Connecting External Devices” on page 2-17
● “Startup” on page 2-22
● “Data Content” on page 2-23
● “Shutdown” on page 2-23
● “Important Tips” on page 2-23
The Model 5030i instrument, power cord, and operator manual are
shipped in an ISTA 2A-certified packaging and all other items/accessories
are shipped separately. The ISTA 2A-certified packaging is comprised of
the instrument within an inner box which is secured within an outer box
using foam end-caps and corner bracing. In this configuration, the
packaging is ready for shipping by carrier domestically and internationally.
Packaging and
Transport