Instruction manual

Introduction
Specifications
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 1-9
Connecting and Interface Cables, and Vacuum Pump
3-foot heated sample tube
Ambient T/RH Assembly
Consumables for average first year’s operation (ambient)
iPort Software for Local or Remote Communication
Sample Heater
3-foot insulated heater tube
Three Modes of Heater Control OFF – Heater is turned off in non condensing environment
TEMP – fixed sample temperature
RH – Dynamic Heating of sample at set sample RH
threshold (e.g., 50% RH)
Instrument Performance (16.67 l/min, 1s, stable conditions)
Measurement Range: 0 to 1.0, 2.0, 3.0, 5.0, 10.0 mg/m
3
0 to 100, 1,000, 2,000, 3,000, 5,000, 10,000 g/m
3
Minimum Detection Limit: <0.5 g/m
3
(1 hour) @ 2 σ
<0.2 g/m
3
(24-hour) @ 2 σ
Resolution: 0.1 g/m³ (not to be confused with precision)
Precision: ±2.0 g/m³ <80 g/m³; ±5 g/m³ >80 g/m³ (24-hour)
Accuracy for Mass Measurement: ±5% using NIST-traceable mass foil set
Data Averaging and Output
Real-time Mass Conc Average: 1 minute
Long-Term Averaging: 60 to 3,600 sec and 24-hour
Data Output Rate: every 1 second
Operating Range
The temperature of the sampled air may vary between -30 and 50 °C. The 5030i units must be
weather protected within the range of 4 °C to 50 °C.
An optional Complete Outdoor Enclosure provides complete weather protection.
Non-condensing; <95% RH inside 5030i
Sample Flow
Volumetric flow control system uses a calibrated subsonic precision orifice and the measured
ambient temperature and pressure to maintain constant volumetric flow rates.
Nominal Flow Rate: 16.67 L/min
Flow Precision ±2% of measured value
Flow Accuracy <5% of measured value
Data Storage
Internal data logging of user-specified variables; capacity of 190,000 records.