Instruction manual

C-Link Protocol Commands
Communications Configuration
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual B-55
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information. ▲
Send: set addr ip 192.168.1.200
Receive: set addr ip 192.168.1.200 ok
addr nm
This command reports the IP netmask.
Send: addr nm
Receive: addr nm 255.255.252.0
set addr nm mask
This command sets the netmask mask, where mask consists of four numbers
ranging from 0-255 inclusive, separated by “.”.
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information. ▲
Send: set addr nm 255.255.252.0
Receive: set addr nm 255.255.252.0 ok
addr ntp
This command reports the IP address for the network time protocol server.
See “Network Time Protocol Server” in the Communications Settings”
section of the “Operation” chapter for more information.
Send: addr ntp
Receive: addr ntp 10.209.43.237
set addr ntp address
This command sets the network time protocol server address, where address
consists of four numbers ranging from 0-255 inclusive, separated by “.”.
Send: set addr ntp 10.209.43.237
Receive: set addr ntp 10.209.43.237 ok
allow mode cmd
This command reports the current allow mode setting: 1 = allow “set mode
local” and “set mode remote” commands; 0 = ignore “set mode local” or
“set mode remote”commands, according to Table B–7. The default value is
0; ignore the commands. The following example shows that the instrument
is configured to ignore “set mode local” or “set mode remote” commands.
Send: allow mode cmd
Receive: allow mode cmd 0