Instruction manual

C-Link Protocol Commands
Communications Configuration
B-54 Model 5030i SHARP Instruction Manual Thermo Fisher Scientific
This command sets the internal clock (24-hour format). The following
example sets the internal time to 2:15 pm.
Note If seconds are omitted, the seconds default to 00.
▲
Send: set time 14:15
Receive: set time 14:15 ok
addr dns
This command reports the TCP/IP address for the domain name server.
Send: addr dns
Receive: addr dns 192.168.1.1
set addr dns address
This command sets the domain name server address, where address consists
of four numbers ranging from 0-255 inclusive, separated by “.”.
Send: set addr dns 192.168.1.1
Receive: set addr dns 192.168.1.1 ok
addr gw
This command reports the default TCP/IP gateway address.
Send: addr gw
Receive: addr gw 192.168.1.1
set addr gw address
This command sets the default gateway address, where address consists of
four numbers ranging from 0-255 inclusive, separated by “.”.
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
▲
Send: set addr gw 192.168.1.1
Receive: set addr gw 192.168.1.1 ok
addr ip
This command reports the IP address of the analyzer.
Send: addr ip
Receive: addr ip 192.168.1.200
set addr ip address
This command sets the analyzer’s IP address, where address consists of four
numbers ranging from 0-255 inclusive, separated by “.”.
Communications
Configuration