Instruction manual

C-Link Protocol Commands
Commands
B-10 Model 5030i SHARP Instruction Manual Thermo Fisher Scientific
Command Description Page
no or srec Reports number of srecs stored in memory B-32
pm Reports the measured PM concentration B-13
pm 24avg Reports the 24-hour average PM concentration B-13
power up mode Reports/sets the power up mode as local or remote B-59
pres comp Reports/sets pressure compensation to actual or standard B-48
pres std Reports/sets the standard pressure B-49
program no Reports analyzer program number B-60
pump Reports/sets pump on or off B-53
push Simulates pressing a key on the front panel B-44
range Reports/sets current PM range B-49
relay Sets relay logic status for the designated relay(s) B-65
relay stat Reports relay logic status for all relay(s) B-65
reset tape counter Resets the tape count to zero B-26
rh th Reports/sets the current relative humidity threshold for the
detector
B-50
ri (right) Simulates pressing right pushbutton B-44
ru (run) Simulates pressing run pushbutton B-44
sample rh Reports the sample relative humidity B-26
save Stores parameters in FLASH B-53
save params Stores parameters in FLASH B-53
sc (screen) C-series legacy command that reports a generic response
(Use iscreen instead)
B-45
sharp Reports the 1-minute running average SHARP monitor
concentration
B-14
sharp24avg Reads the last calculated 24-hour average SHARP monitor
concentration
B-14
sp field Reports/sets item number and name in scratch pad list B-33
sr Reports the last srec stored B-29
srec Reports maximum number of srecs B-29
srec format Reports/sets output format for srecs (ASCII or binary) B-30
srec layout Reports current layout of srec data B-31
srec mem size Reports maximum number of srecs that can be stored B-31
srec per Reports/sets srec logging period B-31
stream per Reports/sets current time interval for streaming data B-33
stream time Reports/sets a time stamp to streaming data or not B-34