Instruction manual

C-Link Protocol Commands
Commands
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual B-7
Command Description Page
copy lrec to sp Sets/copies current lrec selection into the scratch pad B-28
copy sp to lrec Sets/copies current selections in scratch pad into lrec list B-27
copy sp to srec Sets/copies current selections in scratch pad into srec list B-27
copy sp to stream Sets/copies current selections in scratch pad into stream list B-27
copy srec to sp Sets/copies current srec selection into the scratch pad B-28
copy stream to sp Sets/copies current streaming data selection into the scratch
pad
B-28
crn Reports the current radon concentration B-24
custom Reports/sets defined custom range concentration B-46
data treatment lrec Reports/sets data treatment for concentration values in lrecs B-28
data treatment srec Reports/sets data treatment for concentration values in srecs B-28
date Reports/sets current date B-52
default params Sets parameters to default values B-52
det Reports/sets the status of the detector board B-53
det status Reports the current mass for the detector B-24
dhcp Reports/sets state of use of Dynamic Host Configuration
Protocol (DHCP)
B-57
diag volt det Reports diagnostic voltage levels on the detector board B-24
diag volt iob Reports diagnostic voltage levels on the I/O expansion board B-24
diag volt mb Reports diagnostic voltage levels on the motherboard B-24
diag volt mib Reports diagnostic voltage levels on the measurement
interface board
B-25
diag volt neph Reports diagnostic voltage levels on the nephelometer
interface board
B-25
dig in Reports status of the digital inputs B-62
din Reports/sets digital input channel and active state B-62
do (down) Simulates pressing down pushbutton B-44
dout Reports/sets digital output channel and active state B-63
dtoa Reports outputs of the digital to analog converters per
channel
B-63
en (enter) Simulates pressing enter pushbutton B-44
er Returns a brief description of the main operating conditions
in the format specified in the commands
B-28
erec Returns a snapshot of the main operating conditions
(measurements and status) in the specified format
B-28
erec format Reports/sets erec format B-30