Instruction manual

C-Link Protocol Commands
Commands
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual B-5
Command Description Page
alarm filter tape
status
Reports the filter tape status B-19
alarm flow max Reports/sets flow alarm maximum value B-19
alarm flow min Reports/sets flow alarm minimum value B-19
alarm flow pres max Reports/sets flow pressure alarm maximum value B-19
alarm flow pres min Reports/sets flow pressure alarm minimum value B-19
alarm flow temp
max
Reports/sets flow temperature alarm maximum value B-20
alarm flow temp
min
Reports/sets flow temperature alarm minimum value B-20
alarm ib status Reports the interface board status B-20
alarm io status Reports the I/O expansion board status B-20
alarm mb status Reports the motherboard status B-20
alarm nb status Reports the status of the nephelometer interface board B-20
alarm ncal status Reports the status of the last nephelometer auto-zero
calibration
B-21
alarm neph led cur
max
Reports/sets current nephelometer LED alarm maximum
value
B-21
alarm neph led cur
min
Reports/sets current nephelometer LED alarm minimum value B-21
alarm neph rh max Reports/sets nephelometer relative humidity alarm maximum
value
B-21
alarm neph rh min Reports/sets nephelometer relative humidity alarm minimum
value
B-21
alarm neph temp
max
Reports/sets nephelometer temperature alarm maximum
value
B-22
alarm neph temp
min
Reports/sets nephelometer temperature alarm minimum
value
B-22
alarm sample rh
max
Reports/sets sample relative humidity alarm maximum value B-22
alarm sample rh min Reports/sets sample relative humidity alarm minimum value B-22
alarm status det Reports the detector status B-22
alarm tape counter
max
Reports/sets tape counter alarm maximum value B-23
alarm vac pres max Reports/sets vacuum pressure alarm maximum value B-23
alarm vac pres min Reports/sets vacuum pressure alarm minimum value B-23
allow mode cmd Reports/sets the current “set” allow mode command B-55