Instruction manual

C-Link Protocol Commands
Commands
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual B-3
Table B–1. Error Response Messages
Command Response Description
bad cmd Command is not recognized
too high Supplied value is higher than the upper limit
too low Supplied value is lower than the lower limit
invalid string Supplied string invalid (typically because a letter was detected
when the value should be numeric)
data not valid Supplied value is not acceptable for entered command
can’t, wrong settings Command not allowed for current measurement mode
can’t, mode is service Command not allowed while instrument is in service mode
feature not enabled I/O expansion board is not detected
flags no alarm active No measurement alarms are active
The “save” and “set save params” commands (duplicated for backward
compatibility) store parameters in FLASH memory. It is important that
this command be sent each time instrument parameters are changed. If
changes are not saved, they will be lost in the event of a power failure.
Table B–2 lists the 5030i C-Link protocol commands. The interface will
respond to the command strings outlined below.
Table B–2. C-Link Protocol Commands
Command Description Page
1 Simulates pressing soft key 1 pushbutton B-44
2 Simulates pressing soft key 2 pushbutton B-44
3 Simulates pressing soft key 3 pushbutton B-44
4 Simulates pressing soft key 4 pushbutton B-44
addr dns Reports/sets domain name server address for Ethernet port B-54
addr gw Reports/sets default gateway address for Ethernet port B-54
addr ip Reports/sets IP address for Ethernet port B-54
addr nm Reports/sets netmask address for Ethernet port B-55
addr ntp Reports/sets IP address for network time protocol server B-55
alarm alpha count
max
Reports alpha count alarm maximum value B-14
alarm alpha count
min
Reports alpha count alarm minimum value B-14
alarm amb rh max Reports/sets ambient relative humidity alarm maximum value B-14
Commands List