Instruction manual

Model 5014i to 5030i Upgrade Procedures
Radius Tube Adapter Installation
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 10-5
CONNECT TO SHARP 1
2-PIN IS NOT USED
Figure 10–4. Connecting Connection Bracket Wiring to Measurement Interface
Board
Use the following procedure for radius tube adapter installation.
1. Loosen the Radius Tube Mounting bracket screws.
2. Slide back bracket downwards.
3. Slowly remove the existing Radius Face Seal by pulling straight up with
a twisting action.
4. Slowly insert the Radius Tube Adapter onto the Radius Tube and push
down with a slight twist until it is seated.
5. Tighten the radius tube mounting bracket screws as shown in Figure
10–5.
Radius Tube
Adapter Installation