Instruction manual

Operation
Volumetric Conditions
Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 3-43
The Netmask screen is used to edit the netmask. The netmask is used to
determine the subnet on which the instrument can directly communicate
to other devices. The netmask can only be changed when DHCP is off. If
DHCP is on, the instrument will respond with “NOT SETTABLE IF
DHCP IS ON”. For more information on DHCP, see “Use DHCP”
above.
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Netmask.
NETMASK:
CURRENT: 255.255.252.0
SET TO: 255.255.252.0 0
§¨ MOVE CURSOR
©ª CHANGE VALUE
 SAVE VALUE
RANGE AVG DIAGS ALARM
The Default Gateway screen is used to edit the gateway address. The
default gateway can only be changed when DHCP is off. If DHCP is on,
the instrument will respond with “NOT SETTABLE IF DHCP IS ON”.
For more information on DHCP, see “Use DHCP” above. Any traffic to
addresses that are not on the local subnet will be routed through this
address.
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Gateway.
DEFAULT GATEWAY:
CURRENT: 10.209.42.1
SET TO: 10.209.42.1 1
§¨ MOVE CURSOR
©ª CHANGE VALUE
 SAVE VALUE
RANGE AVG DIAGS ALARM
The Host Name screen is used to edit the host name. When DHCP is
enabled, this name is reported to the DHCP server.
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Host Name.
Netmask
Default Gateway
Host Name