Instruction manual

Operation
Volumetric Conditions
3-42 Model 5030i SHARP Instruction Manual Thermo Fisher Scientific
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings.
TCP/IP SETTINGS:
>USE DHCP OFF
IP ADDR 10.209.40.149
NETMASK 255.255.252.0
GATEWAY 10.209.42.1
HOST NAME ISERIESª
RANGE AVG DIAGS ALARM
NTP SVR 10.209.43.237
The Use DHCP screen is used to specify whether to use Dynamic Host
Configuration Protocol (DHCP) or not. When DHCP is enabled, the
network dynamically provides an IP address for the instrument.
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Use DHCP.
DHCP:
CURRENTLY: OFF
SET TO: ON ?
 TOGGLE VALUE
CYCLE POWER TO CHANGE DHCP
RANGE AVG DIAGS ALARM
The IP Address screen is used to edit the IP address. The IP address can
only be changed when DHCP is off. If DHCP is on, the instrument will
respond with “NOT SETTABLE IF DHCP IS ON”. For more
information on DHCP, see “Use DHCP” above.
● In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > IP Addr.
IP ADDRESS:
CURRENT: 10.209.40.149
SET TO: 10.209.40.149 1
§¨ MOVE CURSOR
©ª CHANGE VALUE
 SAVE VALUE
RANGE AVG DIAGS ALARM
Use DHCP
IP Address