Specifications

1/2/07 CD-SW330H_EN.fm
E-40
TINSZA165AWZZ
6
ENGLISH
CD-SW330H
References
 Headphones
z Before plugging in or unplugging the headphones, reduce the
volume.
z Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
z Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
 General
 CD player
Symptom Possible cause
z The clock is not set to the
correct time.
z Did a power failure occur? Reset
the clock. (Refer to page 12.)
z When a button is pressed,
the unit does not respond.
z Set the unit to the power stand-
by mode and then turn it back on.
z If the unit still malfunctions, reset
it. (Refer to page 42.)
z No sound is heard. z Is the volume level set to “0”?
z Are the headphones connected?
z Are the speaker wires discon-
nected?
Symptom Possible cause
z Playback does not start. z Is the disc loaded upside down?
z Playback stops in the mid-
dle or is not performed
properly.
z Does the disc satisfy the stan-
dards?
z Is the disc distorted or
scratched?
z Playback sounds are
skipped, or stopped in the
middle of a track.
z Is the unit located near excessive
vibrations?
z Is the disc very dirty?
z Has condensation formed inside
the unit?