Operation Guide

15 E
E
E
E
E
BEFORE OPERATING
Before operating your new Convection Microwave Drawer, make
sure you read and understand this operation manual completely.
• Before the Convection Microwave Drawer can be used, follow
these steps:
1 Plug in the Convection Microwave Drawer. ENJOY YOUR
OVEN TOUCH CLEAR will appear.
2 Touch the STOP/CLEAR pad. : will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/SETTINGS pad once.
2 Touch number pads for correct time of day, touch START/
+30 SEC.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, ERROR will appear in the display. Touch the STOP/
CLEAR pad and re-enter the time.
• If the electrical power supply to your Convection Microwave
Drawer should be interrupted, the display will intermittently
show ENJOY YOUR OVEN TOUCH CLEAR after the power
is reinstated. If this occurs during cooking, the program
will be erased. The time of day will also be erased. Simply
touch STOP/CLEAR pad and reset the clock for the correct
time of day.
Note:
• The Convection Microwave Drawer can be programmed with
the drawer open except for START/+30 SEC.
TIME INCREMENTS
CONVECTION VS. MICROWAVE
The Convection Microwave Drawer contains two different
categories of cooking, convection and microwave. Due to their
inherent differences, the time increments needed for their cook-
ing are not the same. Convection items tend to cook longer and
microwave items tend to cook quickly. Depending on which
category you are using, the display provides an indicator to easily
distinguish which time increment is being used.
For convection cooking items, "H" will be displayed. This
represents the time increments of Hours and Minutes. Hours
will be shown to the left of the colon, minutes to the right.
For microwave cooking items, "M" will be displayed. This
represents the time increments of Minutes and Seconds. Minutes
will be shown to the left of the colon and seconds to the right.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Convection Microwave Drawer temporarily during
timed cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
OPEN OR CLOSE CONVECTION
MICROWAVE DRAWER
The Convection Microwave Drawer may be opened by any of
the following methods:
• Touch the OPEN/CLOSE pad on the glass touch control.
Touch OPEN/CLOSE again or gently push on the drawer
to close.
• Wave twice on top left side of the drawer to open the oven
drawer. The Easy Wave Open only works to open the drawer.
Gently push on drawer or touch OPEN/CLOSE to close.
• Touch the OPEN DRAWER button on the app after pairing
your appliance to the Sharp Kitchen app. The app only works
to open the drawer. Gently push on drawer or touch OPEN/
CLOSE to close.
Do not pull the drawer by hand, except in the case of a power
failure.
EASY WAVE OPEN ON/OFF
Easy Wave Open's default setting is OFF when plugged in. The
white light on the center of the panel will illuminate once Easy
Wave Open has been activated. When Control Lock is activated,
the Easy Wave Open function is off.
To use the Easy Wave Open function, simply wave your hand
in front of the sensor twice in consecutive motions. This can be
either up and down or side to side motions.
EASY WAVE OPEN ON
• Hold Number 5 on the glass touch control for 3 seconds. The
display shows EASY WAVE OPEN ON.
EASY WAVE OPEN OFF
• Hold Number 5 on the glass touch control for 3 seconds. The
display shows EASY WAVE OPEN OFF.