Use and Care Manual
11
TIME COOKING
Your Microwave Drawer can be programmed for 99 minutes 
99 seconds (99.99). Always enter the seconds after the 
minutes, even if they are both zeros.
•  Suppose you want to cook for 5 minutes at 100%.
1  Enter cooking time 5 0 0. 
5.00
TOUCH
START
OR
TOUCH
POWER
LEVEL
2  To cook at 100% power (High), touch START/+30 SEC 
pad.
TO SET POWER LEVEL
There are eleven preset power levels.
Using lower power levels increases the cooking time, which 
is recommended for foods such as cheese, milk and long slow 
cooking of meats. Consult a microwave cookbook or recipes 
for specic recommendations.
•  Suppose you want to defrost for 5 minutes at 30%.
1  Enter defrost time 5 0 0. 
5.00
2 Touch POWER LEVEL pad 8 times.
3 Touch START/+30 SEC pad.
TOUCH POWER 
LEVEL PAD 
NUMBER OF 
TIMES FOR 
DESIRED POWER
APPROXIMATE 
PERCENTAGE 
OF POWER
COMMON 
WORDS 
FOR POWER 
LEVELS
POWER LEVEL x 1  100%  High
POWER LEVEL x 2  90%   
POWER LEVEL x 3  80% 
POWER LEVEL x 4  70%  Medium High
POWER LEVEL x 5  60% 
POWER LEVEL x 6  50%  Medium
POWER LEVEL x 7  40% 
POWER LEVEL x 8  30%  Med Low/Defrost
POWER LEVEL x 9  20% 
POWER LEVEL x 10  10%  Low
POWER LEVEL x 11  0% 
SENSOR SETTINGS
Sharp's Sensor is a semi-conductor device that detects the 
vapor (moisture and humidity) emitted from the food as it 
heats. The sensor adjusts the cooking times and power levels 
for various foods and quantities.
USING SENSOR SETTINGS:
  1   After the Microwave Drawer is plugged in, wait 2 
minutes before using any sensor setting.
 2  Be sure the exterior of the cooking container and the 
interior of the Microwave Drawer are dry. Wipe off any 
moisture with a dry cloth or paper towel.
 3   The sensor works with foods at normal storage 
temperature. For example, popcorn would be at room 
temperature.
 4   Any sensor selection can be programmed with More or 
Less Time Adjustment. See page 18.
 5  More or less food than the quantity listed in the charts 
should be cooked following the guidelines in any 
microwave cookbook.
 6  During the rst part of sensor use, the food name will 
appear on the display. Do not open the Microwave 
Drawer or touch STOP/CLEAR during this part of the 
cycle. The measurement of vapor will be interrupted. If 
this occurs, an error message will appear. To continue 
cooking, touch the STOP/CLEAR pad and cook 
manua l ly.
    When the sensor detects the vapor emitted from the 
food, the remainder of cooking/reheating time will 
appear. The Microwave Drawer may be opened when 
the remaining time appears on the display. At this time, 
you may stir or season food, as desired.
 7  Except for Popcorn, if the sensor does not detect vapor 
properly when cooking other foods, 
ERROR
 will be 
displayed, and the microwave will turn off.
 8  Check food temperature after cooking. If additional 
time is needed, continue to cook manually.
 9  Each food has a cooking hint. Touch the TIMER/
SETTINGS pad when the HELP indicator is lighted 
in the display.
MICROWAVE DRAWER COOKING










