Operation Manual

10
Plug power supply cord into a standard 3-pronged
13 Amp, 120V AC 60Hz power outlet.
After placing the food in a suitable container, open
the oven door and put it on the glass tray.
The glass tray and roller guide must always be in
place during cooking.
Close the door. Make sure that it is firmly closed.
The oven light is on when the microwave oven is
operating.
The oven door can be opened at any time during
operation by pushing the door open button of
control panel. The oven will automatically shut off.
Each time a pad is pressed, a BEEP will sound to
acknowledge the press.
The oven automatically cooks on full power
unless set to a lower power level.
The display will show “ : 0” when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the STOP/CLEAR pad is pressed during the
oven operation, the oven stops cooking and all
information retained. To erase all information(except
the present time), press the STOP/CLEAR pad once
more. If the oven door is opened during the oven
operation, all information is retained.
If the START pad is pressed and the oven does not
operate, check the area between the door and door
seal for obstructions and make sure the door is
closed securely. The oven will not start cooking until
the door is completely closed or the program has
been reset.
1
2
3
4
5
6
7
8
19
10
11
Make sure the oven is properly installed and
plugged into the electrical outlet.
WATTAGE OUTPUT CHART
•
The power-level is set by pressing the Power Level pad and number pad. If you wish to use a different power
level, press the POWER LEVEL pad before pressing START pad. Enter the power level desired by pressing the
appropriate number pad. The chart shows the display, the power level and the percentage of power. (See TIME
COOK Cooking Guide)
OPERATION PROCEDURE
This section includes useful information about oven operation.
PRESS POWER PAD AND NUMBER POWER LEVEL (DISPLAY) APPROXIMATE PERCENTAGE OF POWER
POWER LEVEL + 1 + 0 PL10 100%
POWER LEVEL + 9 PL-9 90%
POWER LEVEL + 8 PL-8 80%
POWER LEVEL + 7 PL-7 70%
POWER LEVEL + 6 PL-6 60%
POWER LEVEL + 5 PL-5 50%
POWER LEVEL + 4 PL-4 40%
POWER LEVEL + 3 PL-3 30%
POWER LEVEL + 2 PL-2 20%
POWER LEVEL + 1 PL-1 10%
POWER LEVEL + 0 PL-0 0%
NOTE:If “PL-0” is selected, the oven will work with the fan but no power. You can use this level to remove odors.