Installation Instructions
E 2
1. Prepare cabinet opening as shown in Figure 2.
2. Place the drawer adjacent to the wall or cabinet opening. Plug
the power supply cord into the electrical outlet.
3. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and also pinching
the cord between the oven and the wall.
4. Slidethedrawerallthewaybackuntilthesiderailsareush
with the face of the cabinet.
5. Open the drawer. Using the 4 holes on the drawer as a template,
pre-drill the cabinet using a 1/16” (1.6 mm) bit. Secure the
drawer with the 4 screws supplied. See Figure 3.
Figure 3
Figure 4
Side
Rail
6. Close drawer to complete oven installation. See Figure 4.
Figure 2
A. 6" (152.4 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127.0 mm)
E. 3-1/2" (88.9 mm)
F. 4" (101.6 mm)
G. 22-1/8" (562.0 mm) opening
H. 14-13/16" (376.2 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.2 mm) overlap
J. 23-1/2" (596.9 mm) minimum depth
K. Allow 7/16" (11.1 mm) overlap
L. 36" (914.4 mm) countertop height
M. Allow 7/16" (11.1 mm) minimum space
N. Floor must support 100 lb (45.4 kg)
O. Allow 4-1/8" (104.4 mm) minimum space
P. 15-9/16" (395.3 mm) opening
Q. 30" (762.0 mm) minimum width
B
C
D
E
F
G
H
I
I
O
J
K
L
Q
M
N
P
A
O
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1-1/2" diameter
hole and deburred of all sharp edges.
IMP O R TANT
Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.