Operation Manual
Table Of Contents
- (B059)_cover
- (B059)_Eng
- WARNING
- CAUTION
- INSTALLATION
- WARNING
- 1 Keep adequate ventilation space around the refrigerator.
- 2 Using the two front adjustable feet, ensure that the refrigerator is positioned firmly and level on the floor.
- 3 Remove the 2 screws of the cabinet lower part, and use these to fit the foot covers. (supplied inside the refrigerator compartment)
- 4 Connect the power plug to a 230/240 volt. 10 amp. power point.
- DESCRIPTION
- 1. Freezer shelf
- 2. Ice cube maker
- 1) Do not over fill the Ice cube trays; otherwise the ice cubes will be joined together when frozen.
- 2) When the ice cubes are made, turn the lever clockwise to empty the ice into the Ice cube box.
- 3. Ice cube box
- 4. Fresh case & door
- 5. Refrigerator light
- 6. Temp. control knobs
- 7. Refrigerator shelves (2 pcs.)
- 8. Hybrid cooling panel (Aluminum panel)
- 9. Fruit and vegetable shelf
- 10. Fruit and vegetable crisper (2 pcs.)
- 11. Adjustable feet & covers (2 pcs.)
- 12. Magnetic door seals (2 pcs.)
- 13. Flexible pocket
- 14. Door pockets (2 pcs.)
- 15. Water tank
- 16. Utility pockets (2 pcs.)
- 17. Egg holder
- 18. Bottle pocket
- 19. Bottle stopper / Tube stand
- 20. Water dispenser
- WATER DISPENSER
- WARNING
- How to dispense water
- WARNING
- IMPORTANT
- 1 Remove the accessories e.g. shelves from the cabinet and door. Wash them in warm soapy dishwashing water; rinse in clean water and dry. (Only fruit and vegetable shelf is not removable.)
- 2 Clean the inside with a cloth soaked in warm soapy dishwashing water. Then, use cold water to wipe off soapy water.
- 3 Wipe the exterior with a soft cloth each time it is soiled.
- 4 Clean the magnetic door seal with a toothbrush and warm soapy dishwashing water.
- 1 Push the lever and let out all water in the water tank.
- 2 Remove the pipe cover. Disconnect the both ends of the joint pipe.
- 3 Remove the water tank from the door.
- 4 Remove the cover and take out the mesh filter.
- 1. Remove all food.
- 2. Remove the power plug from the power point.
- 3. Clean and dry the interior thoroughly.
- 4. Ensure that all the doors are wedged open slightly for air circulation.
- BEFORE YOU CALL FOR SERVICE
- SPECIFICATION
55
WARNING
■ Unplug the refrigerator first to prevent electric
shock.
■ Do not splash water directly on the outer cabinet
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips:
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
• Wipe any spills from the refrigerator immediately, as acid
or alkaline in the food can cause cracking and staining of
plastic parts.
1
Remove the accessories e.g. shelves from the cabinet
and door. Wash them in warm soapy dishwashing
water; rinse in clean water and dry.
(Only fruit and vegetable shelf is not removable.)
2
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3
Wipe the exterior with a soft cloth each time it is soiled.
4
Clean the magnetic door seal with a toothbrush and
warm soapy dishwashing water.
NOTE
• Do not use hot water, household cleaning powders, creams
or spray-on cleaning products, or any other cleaning
products such as mineral turpentine, methylated spirits,
thinners, petrol etc. These may damage your refrigerator
and may void any warranty.
• If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
• The glass shelves weigh approximately 3 kg each. Hold
firmly when removing from the cabinet or carrying.
• Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
How to remove the water tank
(Cleaning once a month is recommended.)
1
Push the lever and let out all water in the water tank.
2
Remove the pipe cover.
Disconnect the both ends of the joint pipe.
3
Remove the water tank from the door.
4
Remove the cover and take out the mesh filter.
NOTE
Ensure that all parts are reassembled. Incorrect assembly
may cause water leakage.
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
symptom of mould:
1. Remove all food.
2. Remove the power plug from the power point.
3. Clean and dry the interior thoroughly.
4. Ensure that all the doors are wedged open slightly for
air circulation.
CARE AND CLEANING
Pipe cover
Joint pipe
To attach
Door
Water tank
2
1
To attach
Mesh
filter
Cover
(B059)_Eng.fm Page 5 Thursday, September 17, 2009 10:58 AM