User Manual

89
KEY OPERATOR PROGRAMS
Key operator programs
P25 Setting a Maximum Number of Copies
Use P25 to limit the maximum number of copies per copy run which
can be input in the copy quantity display.
When P25 is entered, the following message will appear.
P25: SETTING A MAXIMUM NUMBER OF
COPIES. ENTER THE NUMBER AND PRESS
THE START KEY. –––
Input the number using the 10-key pad and press the
START key.
●
A number from 1 to 999 can be set.
P26 Initial Margin Shift Setting
Set the initial margin shift value with this program.
When P26 is entered, the following message will appear.
P26: INITIAL MARGIN SHIFT SETTING.
SIDE 1 SIDE 2
AMOUNT PRESS AMOUNT PRESS
0 1 0 1
3mm 2 3mm 2
6mm 3 6mm 3
9mm 4 9mm 4
12mm 5 12mm 5
15mm 6 15mm 6
Select the desired values for the front side (side 1) and the
second side (side 2) using the 10-key pad.
●
If an optional duplex module is not installed, the value for the
second side (side 2) cannot be set.
P27 Erase Width Adjustment
Set the amount of the erase area with this program.
When P27 is entered, the following message will appear.
P27: ERASE WIDTH ADJUSTMENT.
FOR EDGE ERASE MODE.
1:0—6mm 2:6—12mm 3:12—18mm
1. Make the selection for edge erase using the 10-key
pad.
●
The following message will appear.
FOR CENTRE ERASE MODE.
1:10mm 2:15mm 3:20mm
2. Make the selection for centre erase using the 10-key
pad.
(For inch system machines, the
margin shift values are 0, 1/8",
1/4", 3/8", 1/2", and 5/8".)
(For inch system machines, the
edge erase values are 1: 0-1/4",
2: 1/4"-1/2", and 3: 1/2"-3/4".)
(For inch system machines, the
centre erase values are 1: 2/5",
2: 3/5", and 3: 4/5".)