User Manual
79
KEY OPERATOR PROGRAMS
Key operator programs
KEY OPERATOR PROGRAMS
A complete list of all key operator programs is provided below. These programs can
only be accessed by first entering the key operator code number.
If an optional Card Counter (SF-EA11) or Auditor (SF-EA12) is installed, key operator
programs 10, 11, 13, 14, 16 and 18 cannot be accessed by way of the copier keys. In
this case, settings for the auditing programs must be selected by using an optional
Counter Commander (SF-EA13). The operation of the SF-EA11, SF-EA12, and SF-
EA13 auditing system is described in a separate manual.
Program Page
Code No. Program Name Function No.
P10 Auditing Mode Enables or disables the basic auditing mode, which 82
controls access to copier.
P11 Number of Copies Displays the total number of copies made against 82
per Account account numbers.
P13 Resetting Account Resets all audit accounts or selectively resets 82
individual accounts.
P14 Account Number Registers accounts, deletes accounts, changes an 83
Control account number, or displays all registered account
numbers.
P16 Account Limit Sets the maximum number of copies which can be 85
Setting made against a registered account number.
P18 Account Number Guards against trial and error entering of audit 86
Security account numbers.
P19 Key Operator Code Changes the key operator code number. 87
Number Change
P20 Auto Exposure Lightens or darkens copies in the automatic 87
Adjust exposure mode.
P21 Auto Power Sets a time interval after which the copier 87
Shut-off Timer automatically turns off.
P22 Toner Save Mode Reduces toner consumption. 87
P23 Auto Clear Setting Sets a time interval after which the copier returns 88
to the initial settings.
P24 Add or Change Adds or changes a reduction or enlargement 88
Extra Preset Ratio preset copy ratio.
P25 Setting a Maximum Sets the maximum number of copies that can be 89
Number of Copies selected.
P26 Initial Margin Shift Sets the initial margin shift values. 89
Setting
P27 Erase Width Sets the amount of the erase area. 89
Adjustment
P28 Initial Status Sets the copier’s initial settings in the ready 90
Setting condition.
P29 Total Copy Count Recalls the total copy counts of the copier, 90
document feeder, duplex module, and stapler.