User Manual

SUPPLIES

ADDING TONER

The message “TONER SUPPLY IS LOW. PRESS THE KEY

FOR INSTRUCTIONS.” will appear in the message display before

the toner supply is completely empty. If copying is continued, copies

will gradually become lighter until the copier stops and the message

display changes to “ADD TONER. PRESS THE

KEY FOR

INSTRUCTIONS ON HOW TO ADD TONER.”, indicating that the

toner supply is empty. Toner can be added any time after the

message “TONER SUPPLY IS LOW. PRESS THE

KEY FOR

INSTRUCTIONS.” appears. To add toner, stop the copier and

proceed as below. When either of these messages appears, you can

use the INFORMATION and SCROLL DISPLAY keys for detailed

information as necessary.

During long copy runs of multiple dark originals, “TONER RE-

PLENISHMENT IN PROGRESS.” will appear and the copier will stop

making copies even though toner is left.

After a sufficient amount of toner has been fed, the START key

indicator will light up. Press the START key to resume copying.

Open the front cover.

Pull down the toner hopper lock lever and pull the toner

hopper out slowly until it stops.

Hold the toner cartridge vertically and vigorously shake

it up and down about 20 times to loosen the toner. This

will allow the toner to flow more easily into the toner

hopper.

For best copying results, be sure to use

only Sharp products.

The package of Sharp toner has the

Genuine Supplies label.

Adding toner