Owners Manual

ERROR CODES

SHARP ELECTRONICS CORPORATION • 100 Paragon Drive • Montvale, New Jersey 07645 • USA

When some malfunctions occur, the appliance will display error codes to warn you:

CODES MEANINGS POSSIBLE CAUSES

E1 • Longer inlet time • Faucet is not opened, or water intake is restricted, or water pressure is

too low

• Improper or Incomplete Draining • Drain Hose is extended more than 10 ft from Dishwasher

• Drain Hose is not properly looped underneath sink, or not installed

with Air Gap

• Drain Hose is kinked, compressed, or otherwise damaged

• Wrong Drain Hose used (use only supplied Sharp Dishwasher Drain

Hose)

E4 Overow Some element of dishwasher leaks

E8 Failure of orientation of distributary valve Open circuit or break of distributary valve

E9 Holding a button for longer than 30 seconds Water or some other material on the button

WARNING

• If overow occurs, turn off the main water supply before calling for service.

• If there is water in the base pan because of an overll or small leak, the water should be removed before restarting the dishwasher.

INCORRECT CORRECT - METHOD 1

AIR GAP WITH WASTE TEE OR DISPOSER

INCORRECT CORRECT - METHOD 2

HIGH DRAIN LOOP WITH WASTE TEE OR DISPOSER