Specifications

Maxiva UAX
October 17, 2013
5‐49
888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.
Copyright©2013,HarrisBroadcast
Figure 5-33 Program Box
STEP 7
Select[Program].Theaddressbardisplaywillchangeto192.168.117.88/
Program.
STEP 8 Afterabout5minutesthedisplaywillchangetoreadProgrammingFlash&
LPUReboots.WaitfortheLPUreboottooccur(LEDsonfrontwillblinkand
fanswillslow)thenclosethebrowsersession.
STEP 9 Procedurecomplete.
5.9.9.2 BootloaderRecoveryProcedure
ThefollowingprocedurecanbeusedifconnectiontothefrontEthernetportisnotsuccessful.Theprocedure
invokesthebootloadertoactivateEthernetportsandallowsoftwareupdates.
STEP 1
ConnectastandardethernetcablefromPC/laptoptotheethernetporton
thefrontoftheLPU.
STEP 2 ConnectaserialcablefromPC/laptoptotheRS‐232connectorontherear
oftheLPU.
STEP 3 StartaterminalprogramsuchasTeraTermProorHyperterminal.Makesure
itistheactivewindow.SelectSerialandthenSetuptabandSerialPortto
configureTeraTerm.SeesettingsinFigure5‐34onpage5‐49.
Figure 5-34 Teraterm Serial Port Setup Screen
Note
The active Com port on the PC must be selected as the Port value. This may vary from PC to PC.