Operation Manual

18E

1 Select heater by touching ON keypad.

2 Use the Power Slider Bar selector to set power level.

3 Touch the TIMER +/- keypads; a tone will sound and the

Indicator Light Timer ON for the heater will blink. Use the

keypads to select desired time and touch ON again to accept.

4 Touch ON or wait 5 seconds for the power to be automatically

accepted and heater to begin heating.

5 A tone will sound and the Indicator Light Timer ON will

illuminate and remain on during the countdown. (If it is the

default timer countdown displayed, this light will blink.)

If using BRIDGE with the 2 left heaters, simply operate the

bridge function as instructed in the section BRIDGE HEATER

and select one of the TIMER keypads to set time as the heaters

will sync power and timer.

SET MULTIPLE TIMERS

Complete the steps for setting a single timer, and simply repeat

for the next desired heater.

SET AN INDEPENDENT TIMER

Simply select the +/- keypads and set a timer countdown. The

independent timer can be set even if the cooktop main power is

off (Control Lock must be deactivated). The independent timer

will continue to operate even if cooktop main power is turned

off. When setting the independent timer, a small red decimal

will ash at the bottom right corner of

the Timer Digital Display indicating that

this the independent timer is being set. It

will ash for 5 seconds, or until a heater

is selected.

When the timer countdown has completed, a tone will sound

(2 rapid succession beeps) and 00 will blink in the display for

1 minute or until any keypad is touched on the control panel.

SETTING A SINGLE TIMER