Instruction manual

Detector Specifications
Dimensions:
The tunnels in the R8000 and R9500 are approximately rectangular.
The R8000 tunnel’s inside dimensions are 4 inches (10.2 cm) high and 7 7/8 inches
(20.0 cm) wide. The detector itself is 15 ½ inches wide (39.4 cm), 11 7/8 inches high
(30.2 cm), and 41 3/8 inches long (1.05m). The detector alone weighs 64 pounds (29
kg).
The 9500 tunnel’s inside dimensions are 4 5/8 inches (11.7 cm) high and 9.5 inches
(24.1 cm) wide. The detector itself is 17 1/8 inches wide (43.5 cm), 13 inches high
(33.0 cm), and 48 1/2 inches long (41.37 m). The detector alone weighs 98 pounds
(44.5 kg).
Power Consumption
The detector draws 35 mA @ 5volts dc at rest. With all LEDs lit, and audio alarm
sounding, it draws 124 mA max. If a gate is attached and the detector is at rest, the
detectors draw 32 mA.
The gate alone draws 13 mA at rest.
Wiring of Power Connector
The Power Connector on the rear panel of the detector has four pins. The power cable
from either the NMT R-Series Power supply or the battery pack attaches to this
connector when a gate is not in use.
Pin 1 = empty
Pin 2 = the supplied voltage (6 to 40 volts dc), if using the supplied 12 volt
battery it would be +12 volts dc
Pin three = empty
Pin 4 = ground
Wiring of Electronics Connector
The Electronics Connector on the rear panel of the detector has four pins. The Cable
to R Detector from the gate attaches to this connector.
Pin 1 = the Signal to the gate
Pin 2 = tachometer (for use with conveyor belt)
Pin 3 = +5 volts (from gate)
Pin 4 = ground
R-Series Instruction Manual 45