Instruction manual

Quad Counter cable connections.
1. The Counter Cable with Sensors connects to the connector at the rear face of
the switch box. The sensors install into the gate sensor brackets in the same
way as for the Dual Counter.
2. The short upper cable coming out of the upward facing side of the switch box
connects to the upper counter,
3. The short lower cable coming out of the upward facing side of the switch box
connects to the lower counter.
4. The Double Foot Switch plugs into the connector on the downward facing side
of the switch box.
5. The Quad Counter Power Cable coming out of the switch box connects to the
“Cable to R Detector” that comes from the gate.
6. The short cable with connector on the Quad Counter Power Cable plugs into
the “Electronics Connector” on the rear panel of the detector.
See the following pages for photos of Quad Counter Cable Connections.
R-Series Instruction Manual 20