Instruction manual

Gate Electronics Box
The front side of the Gate Electronics Box has seven items: a Power Input
Connector, a cable for connecting to the R Detector, a vertically toggled Power
Switch a horizontally toggled Direction Switch, an audio Error Alarm, an LED
indicating Power On, and an LED indicating a Low Battery.
The Power Input Connector on the R-Series Gate connects to either NMT's R-
Series Power Supply, which in turn is plugged into a standard 120VAC outlet, or
to a 12 volt DC power source such as the supplied 12 volt sealed lead acid
battery.
The end of the Cable to R Detector connects to the Electronics Connector on
the rear panel of the detector. It receives the activation signal from the Detector
and also supplies the Detector with 5-volt power.
The Power Switch toggles up for on and down for off. If there are C-cells in the
Detector and the Gate power is turned off before the Detector is turned off, the
Detector Loss of Power Alarm will sound.
End View of Gate Electronics Box
R-Series Instruction Manual 14