Operation Manual

ManualsBrandsSharp ManualsCookingSharp Heavy-Duty 1200 Watt Commercial Microwave Oven

A37564,R22GV,/22GT/23GT/24GT/25JT

Receptacle Box Cover

3-Pronged plug

(6-20P) R-25JTF

3-Pronged, Receptacle

(6-20R)

230 V

208 V

(A)

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of

electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord

having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly

installed and grounded.

WARNING – Improper use of the grounding plug can result in a risk of electric shock. The electrical

requirements are 120 Volt, 60 Hz AC only, 20 Amp or more (R-22GTF); and 20 Amp or more (R-25JTF)

fused electrical supply. It is recommended that a separate circuit serving only this appliance be

provided. When installing this appliance, observe all applicable codes and ordinances. If it is necessary

to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot

receptacle that will accept the plug on the appliance. The marked rating of the extension cord should be

AC 120 Volt 20 Amp (R-22GTF), AC230/208 Volt 20 Amp (R-25JTF). Consult a qualified electrician or

serviceman if the grounding instructions are not completely understood or if doubt exists as to whether

the appliance is properly grounded.

230/208V 20A

R-25JTF

120V 20A

R-22GTF

Receptacle Box Cover

3-Pronged plug

(5-20P)

3-Pronged, Receptacle

(5-20R)

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the

microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the

oven as feasible or check position and signal of receiving antenna.

VOLTAGE SELECT

The R-25JTF has been preset for 208V operation.

If you need to change this oven for 230V operation,

follow instructions below.

1. Unplug oven.

2. Remove one screw(A) from the Voltage Select

Cover located on back of the oven near the

bottom.

3. Remove the Voltage Select Cover and rotate 180

degrees.

4. Reinstall the Voltage Select Cover using one

screw(A) removed in Step 2.

5. Plug power cord into wall outlet.

Your oven is now ready for 230V, 60Hz operation.

Note: If “EE4” or “EE5” appears in the lighted digital

display, a voltage adjustment must be made.