Specifications

LPKF ProtoMat 95s/II commands
82 ProtoMat 95s/II
10.1.3 Special command for the high-speedcycle spindle
Before communicating with the high-speedcycle spindle, send the
command for opening the SERIAL2 (!OC;), then the serial interface
SERIAL2" must be closed again (!CC;)
!RM (r){;}
Revolutions Motor, r=0...60.
Sets the speed (r)*1000 of the high-speedcycle spindle.
10.1.4 Direct commands
Direct commands are special commands which, once they have been
interpreted, are carried out via the command buffer.
!CB{;}
Clear buffer
Deletes all commands from the command buffer.
!GO{;}
Go on
Removes the stop command and continues the command
implementation.
!RC{;}
Repeat command
Repeats the last command carried out.
!ST{;}
Stop
Interrupts command processing when the current command is
completed.
The command set implemented is a subset of the HP-GL. If the
equipment is to be driven by any CAD system, with HP-GL commands, it
must be ensured that the step size is substantially lower than with
normal pen plotters.
The step size is 6,25 µm/step (5 mm/800 steps).