Specifications

LPKF ProtoMat 95s/II commands
80 ProtoMat 95s/II
10.1.2 Special commands
All special commands begin with the symbol "!" and their syntax is
otherwise like that for HP-GL standard commands.
!AS (a){;}
Acceleration Set
Defines a new acceleration constant a=mm/s
²
. The valid value range is
10...50000.
!CC {;}
Close channel
Ends a data transmission introduced with !OC.
!CM (n){;}
Change mode
Switches between the drill (n=0) and mill (n=1) working modes.
!CT (n){;}
Command counter
Switches between echo mode (n=1) and non-echo mode (n=0). In echo
mode, the machine acknowledges every correctly completed command
with the message "C<cr>".
!EM (n){;}
External motor
Switches the mill/drill motor on (n=1) or off (n=0).
!ES (n){;}
Enable stop
Release (n=1) and block (n=0) the external stop function. After switching
on, the external stop function is blocked.
!FP {;}
Full power
Switches the motors of the XYZ axis to full power.
!HP {;}
Half power
Switches the motors of the XYZ axis to half power.
!OC {;}
Open channel
Opens a direct data transmission from serial data channel SER1 to
serial data channel SER2. All characters received on data channel
SER1 are sent to data channel SER2 until the character string !CC is
received.
!ON (a){;}
Output nominal position
The control unit sends the nominal position (target position) of the motor
axis addressed with parameter a. The following addresses are attributed
to the motor axes:
• 0 = X,Y,Z axis
• 1 = X axis
• 2 = Y axis
• 3 = Z axis