Specifications

Appendix
70 ProtoMat 95s/II
fig. 52:
› Now click on
CLOSE
in the
COLLET
window.
The plotter head collet closes and grips the tool.
› Shift the entire
TOOL MAGAZINE
window down the screen until you
can see the
BoardMaster
main menu bar.
› Enter the value 0.1mm in the step window. Make sure that you enter
a decimal point between the zero and the one.
fig. 53:
› Lift the tool change magazine carefully with both hands (as
shown on Fig. 55 on page 71) observe whether the appropriate
changeover station or collet can be properly moved over the
tool. If it stutters or jams, check carefully in which direction the
position of the plotter head has to be corrected.
1
- Tool ring
2
- Lower plate of the working depth limiter