Specifications

Setup
ProtoMat 95s/II 43
› Mark any old holes with a felt-tip pen so that they cannot be
mistaken for the new holes.
The drilling base should be drilled to a larger diameter, such as 5-6
mm, to allow for inaccuracies in the registration holes. Position the
previously drilled base material and drilling base over the alignment
pins. The format of the base material should be selected so that the
registration hole strip does not need to be moved more than 10 mm.
Moving the registration hole strip more than 10 mm reduces the
accuracy of the registration hole system.
› Now secure the base material in this position on all four sides with
adhesive tape (we recommend Tesakrepp 5250).
Caution! Please note that very sharp tools are involved and that
they may become hot. Always work with the vacuum system
switched on to avoid injury from swarf.
Note: You should select a distance between the registration holes
which allows you to work with standard base material.
A DIN A4 size board has a side length of 297 mm so holes which
are 5 mm from the edge give a distance between the holes of 287
mm.