Specifications

Setup
ProtoMat 95s/II 39
fig. 26:
› The HOME position must be corrected if the milled line does not
pass exactly through the centre point.
This can be done directly by amending the HOME position in the
MACHINE SETTINGS
dialogue box (see „Programming the HOME
position in LPKF BoardMaster“ on page 39.).
The correct value can be calculated using the formula given above.
The Y coordinates must always be
added
to the correction value.
› After making a correction, the process should be repeated as a
check. It is advisable that you use the second hole and milling track
in the test program if the same board is to be used to perform the
check.
› Note the coordinates of the new HOME position.
5.9 Programming the HOME position in LPKF
BoardMaster
The HOME position for the LPKF
ProtoMat
95s/II must be programmed
to lie exactly on the axis of symmetry (the registration hole system with
the red plastic slides) as described for machining double-sided boards.
You must enter a correction if a check shows that the HOME position, as
described above, does not lie on the axis of symmetry.
To do this, proceed as follows:
› Start up
BoardMaster
.
› Select
CONFIGURATION, SETTINGS
from the menu bar.