Specifications

Setup
32 ProtoMat 95s/II
5.3.3 Preparing the tool magazine
The tools fitted with spacer rings are placed into the tool magazine in the
following steps (see „Tools, material and accessories“ on page 44.).
Only tools which are 1/8 inch in diameter and 36 mm or 38 mm in length
may be used.
› Switch on the circuit board plotter. (The x and y-limit switches are
activated)
› Close the hood.
› Start up the
BoardMaster
program.
› Use
BoardMaster
to carry out the following procedures:
• Open the
TOOL POSITIONS
dialogue box by right-clicking on
the arrow in the Tool combo box.
fig. 19:
• Assign the required tools to the tool positions.
Danger! The hood must always be closed whenever there is any
movement during the tool change.
The tool magazine is moved by compressed air. This increases the
risk of fingers being crushed.
› Click on T
OOL BOX UP
to raise the tool magazine.
Any tools held in the plotter head collet are automatically set down
before the tool magazine is raised.
› Open the hood once all movement has ceased.
› Only those tools which have been previously assigned may be
inserted in the tool magazine.
The tools must be inserted as far as the stop and securely held
between the springs.
Tool position 1 is situated at the front to the right.