Instruction manual

22
INM9380-RD-1
May 2012
Assembly label
Terminator marking
9387-FB-PS-R
Fieldbus Barrier Assembly
6 Spur, Redundant, Screw Terminal
Measurement Technology Ltd
Luton, England. Made in England.
www.mtl-inst.com
4176/A
WARNING:- NON-INTRINSICALLY
SAFE CIRCUITS PROTECTED
BY IP30 COVER.
!
SEE INSTRUCTION
MANUAL
- 40°C < Ta < +75°C
SN: XXXXXX-XX
VER: MTXX
Tested
Inspected
Barrier markings
8.3 Inspection and maintenance
a) Inspection and maintenance should be carried out in accordance with European,
national and local regulations which may refer to the IEC standard IEC 60079-17.
In addition specific industries or end users may have specific requirements which
should also be met.
b) Care should be taken to limit dust accumulation on the exterior of the apparatus to a
depth not exceeding 5mm.
c) Maintenance of internal components while powered is limited to those actions
permitted in Section 5 of this manual.
8.4 Repair
The modules used in this product cannot be repaired by the user and must be replaced
with an equivalent certified product.
8.5 Marking
Each certified component is marked in compliance with the Directive and CE marked
with the Notified Body Identification Number.
This information applies to products manufactured during or after the year 2012.
Trunk surge protector marking