Instruction manual

14
INM9380-RD-1
May 2012
4. To restore Barrier A to the “active” mode, press the B
>
A fail-over button located
beside Barrier B. Control of all spurs now returns to Barrier A while Barrier B goes
into “standby” mode.
* NOTE
Operating the fail-over buttons will not allow active spurs to be transfered to a
missing or failed barrier module.
Terminator and Trunk Surge Protection modules












Figure 5.3 - Module connectors and retaining clips
5.2.3 Fitting and removal
Both modules have connectors that are designed to prevent an ignition-capable spark
when the module is installed or removed. The modules are not interchangeable but the
method of installing and removal is the same.
Do not use, or attempt to repair, a module that has any of the pins on its underside
bent or damaged, because this might affect its safety and will invalidate the certification.






Figure 5.4 - Mounting a module - e.g. Trunk Surge Protection module