User manual

32
72-9355 / 72-9360 / 72-9365 / User Manual
7. Storage Setups and Screen Copy
As shown in Figure 2-25, press [SAVE] to access the storage menu.
Save
Recall
Record
Off
Figure 2-25 Storage menu
You can save and recall waveforms and setup documents on the oscilloscope’s internal
memory and any USB device. You can also save and recall waveform documents and
setup documents on a USB device. For setup see the table below.
Table 2-9 Storage menu
Function Menu Setup Explanatory Note
Save See Table 2-10 Save the current setup or waveform.
Recall See Table 2-11 Recall a saved setup or waveform.
Record See Table 2-12 Record and playback a waveform.
OFF Close the recalled waveform.
Save
In the storage menu, press [F1] to select the save function. For setup see the table below:
Table 2-10 Storage menu
Function Menu Setup Explanatory Note
Save Setup
Waveform A
Waveform B
Save the current setups of all menus.
Save the Channel A waveform.
Save the Channel B waveform.
Medium Internal
USB
Save the setup and waveform documents
internally.
Save the waveform document on the USB
device.
Position 1~10 Set and select the storage position with the jog
dial.
Run Run the previously selected operation.
Return Go back to the previous menu.
Example 1: To request saving a Channel A waveform both on the internal memory and
the USB device.
1. Press [A] to select Channel A.
2. Press [SAVE] to access the storage menu, and then press [F1] to select the storage
function.
3. Press [F1] to select “waveform A” as save type.
4. Press [F2] to select internal as the save medium.
5. Press [F3] to select position 2 with the jog dial.
6. Press [F4]. The waveform is successfully saved when the “Saving.......” progress
bar disappears.