Technical information

Operating in Automated Mode
3-16 Tenth Edition 9871
Ejecting Cartridges through the PCAP
To eject a cartridge through the PCAP:
1. Issue the eject command at the operator console.
• The robot places the cartridge into the PCAP.
• The robot audits the PCAP.
• The PCAP status display area on the LSM operator panel displays the
VOLSER of the cartridge.
• A dash in the rectangular box appears in the display area and indicates
that a cartridge is present.
• The panel displays CANT READ if the cartridge is unlabeled or if the
label is unreadable.
2. Open the PCAP door as shown in Figure 3-9 on page 3-14.
• The panel displays EJECT.
3. Remove the cartridge from the PCAP.
4. Close the PCAP door.
• The panel displays LOCKED.
• The VOLSER is replaced by ?????? on the panel.
• The robot audits the PCAP and replaces the question marks with a
blank field, indicating that the status is known and that no cartridge is
present.