Technical information

9871 Tenth Edition 3-13
Operating in Automated Mode
8. Refer to your software user’s guide and restore the CAP to the locked
position.
Ejecting Cartridges through the CAP
To eject cartridges through the CAP:
1. Issue the eject command at the operator console.
• The CAP status display area on the LSM operator panel displays EJECT.
• The robot places cartridges into the CAP until all specified cartridges are
in the CAP or all CAP cells are filled.
• The rectangular boxes on the panel show a dash as each cartridge is
placed in the CAP. The dashes show the number and location of
cartridges in the CAP magazines. The two-digit display field next to the
boxes also shows the number of cartridges placed in the CAP.
2. Open the CAP door.
• The panel displays Door Open.
3. Remove all loaded magazines from the CAP and take the cartridges out of
the magazines.
Notes:
1. You can also remove individual cartridges from the magazines.
2. Do not leave cartridges in the CAP or the panel will display Remove
Cartridges.
4. Place the magazines back into the CAP.
Note: Make sure that the bottom magazine is placed in the CAP.
5. Close the CAP door.
• The panel displays LOCKED when the CAP door is closed and locked
properly.
The robot continues filling the CAP until all the required cartridges have been
ejected. When the panel displays Remove Cartridges EJECT, repeat steps
2 through 5.