Technical information

9871 Tenth Edition 3-11
Operating in Automated Mode
3. Remove the CAP magazines from the LSM door. Lift the magazines up
approximately 25.4 mm. (1 in.) and pull them out, as shown in Figure 3-7.
Note: You can also add cartridges directly to the magazine cells without
removing the magazines from the CAP.
4. Place a cartridge into a magazine cell as shown in Figure 3-8 on page 3-12.
Note: Insert cartridges so they lie flat, with the customer label on top and
the volume serial number (VOLSER) facing you as shown in
Figure 3-8 on page 3-12.
5. Continue until all the cartridges have been placed in the magazines, or until
the magazines are full.
6. Place the magazines back into the CAP.
Note: Make sure that a magazine is always placed into the bottom
magazine area. You do not need to replace the top magazines unless
you need them.
If only the bottom magazine is replaced, the status display for the
CAP on the LSM operator panel shows only the bottom magazine is
present. If only the top magazines are replaced in either the
standard or optional CAP, the status display for the CAPs shows that
no magazines are present, and the robot does not attempt to retrieve
a cartridge from the CAP.
Figure 3-7. Removing Cartridge Access Port Magazines
E40251