Technical information

Cartridge Drive Operator Panel

2-10 Tenth Edition 9871

■ Cartridge Drive Operator Panel

Different drive types use different techniques to display messages and provide

operator interaction. The following pages provide insight to the techniques.

4xxx Operator Panel

The 4xxx CD operator panel inside the LSM contains CD operator switch

assemblies and a CD message display. Indicators are enabled when the LSM is

offline, and disabled when the LSM is online. Refer to your software user’s

guide for a description of using a CD when the LSM is offline.

Figure 2-3 on page 2-11 shows switch and display locations.

Table 2-3 on page 2-12 describes each numbered item.

10 Softkey The second softkey from the left is not implemented.

CONTINUE

During initialization diagnostics, this switch clears a nonfatal

diagnostic failure condition and allows initialization to

continue.

LIGHTS

Toggles the two LSM ceiling lights on and off. The switch on

the TWS card must be in position 3 to activate this.

LSM INFO

Displays the level of microcode installed. Press DONE when

finished.

LCD CONFIG

Adjusts the intensity of the display panel. When this switch is

pressed, the StorageTek logo appears on the panel and

Adjust LCD Brightness appears above the logo.

Lighter, Darker, and DONE appear at the bottom of the

display with a switch for each option. Keep pressing the

lighter or darker switch to adjust the display to the desired

intensity. Press DONE when complete. The normal display

panel is restored.

Notes:

1. Numbers match the item numbers in Figure 2-2 on page 2-5.

Table 2-2. LSM Operator Panel Status Screen

Item

Category Description