Technical information

9871 Tenth Edition 2-9

LSM Operator Panel

7 Indicator Rectangular boxes show the number and location of

magazines in the CAP. If the top magazines are not in CAP 0

or CAP 1, the boxes for those magazines are not shown. If the

bottom magazines are not in CAP 0 or CAP 1, the display does

not show any boxes, even if the top magazines are in place.

This is because the robot audits the CAP by starting at the

bottom of the CAP, and stops performing the audit when no

magazine is found.

Horizontal lines within the boxes show the number and

location of cartridges in each magazine.

During cartridge enter operations, this display increments after

cartridges have been entered into the CAP, the door is closed,

and the robot catalogs the CAP. It decrements as cartridges are

removed from the CAP.

During eject operations, this display increments as cartridges

are placed in the CAP for ejection.

Question marks in the boxes indicate the CAP door had been

opened and the status of cartridges in the CAP is unknown.

8 Indicator The numbers next to CAP 1 and CAP 0 indicate the number of

cartridges in the CAPs.

During cartridge enter operations, this display field increments

after cartridges have been entered into the CAP, the door is

closed, and the robot catalogs the CAP. It decrements as the

cartridges are removed from the CAP.

During cartridge eject operations, this field increments as

cartridges are placed in the CAP for removal.

9 Indicator The rectangular box next to PCAP shows a dash when a

cartridge is present in the PCAP. The box is blank when no

cartridge is present.

The field above the rectangular box displays the volume serial

number of the cartridge being entered or ejected through the

PCAP, if it has a readable label. If the cartridge is unlabeled, or

if the label cannot be read, CANT READ is displayed.

Table 2-2. LSM Operator Panel Status Screen

Item

Category Description