Instruction manual

STP-200/300/400 Series Instruction Manual
7.1.1 Attaching a Baking Heater
1) Attach a baking heater (optional accessory) as near as possible to the inlet
port flange (See Figure 7.1, "Attaching Positions of the Cooling Unit and
Baking Heater").
2) Affix the "Hot Surface Warning Label" to the surface of the STP pump so that
the operator can see it clearly at any time (See Figure 7.1, "Attaching
Positions of the Cooling Unit and Baking Heater").
◇ Check the rated voltage of the baking heater before use.
◇ Wind the baking heater around the surface of the STP pump tightly.
If the baking heater is not wound tightly, the loose parts will
overheat.
◇ Procure protective parts for the baking heater, such as an earth
leakage breaker and fuses, when using the baking heater.
◇ DO NOT apply excessive force to the cable for the baking heater.
7-2