Instruction manual

STP-200/300/400 Series Instruction Manual
4.1.2 Rear Panel
(See Figure 4.2.)
(11) AC POWER Connector (CON30)
・ For primary power input.
(12) MAIN POWER Breaker
・ Switches ON/OFF the primary power.
・ A metal fitting is attached to secure the breaker at the OFF
position.
(13) P. CONNECTOR (CON20)
・ For connection of the STP connection cable.
(14) REMOTE CONNECTOR (CON40)
・ For remote control.
For details of the REMOTE CONNECTOR (14), see Section 8, “Remote
Input/Output Signal Connector.”
(15) "MANUAL/REMOTE" Changeover Switch
・ When setting to MANUAL
, only start, stop or other operations can
be performed with the switches on the STP control unit front
panel.
・ When setting to REMOTE, only start, stop or other operations can
be performed by inputting the remote signal.
(16) EXT. BATTERY Connector (CON90)
・ For connection of an external battery.
◇ When using an external battery, always disconnect the internal
battery connector (See Section 10, "External Battery" for details).
(17) Ground Terminal
・ For connection of the ground cable between the STP pump and the
STP control unit.
(18) Air Cooling Fan
・ For cooling the inside of the STP control unit.
4-3